RIDE-ON ELECTRIC MOTORCYCLE TOY Model 03514 Model 92927 RED BLACK ASSEMBLY AND OPERATING INSTRUCTIONS ® 3491 Mission Oaks Blvd., Camarillo, CA 93011 Visit our Web site at: http://www.harborfreight.com Copyright© 2005 by Harbor Freight Tools®. All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. For technical questions, please call 1-800-444-3353.
PRODUCT SPECIFICATIONS Item Recommended Age Limits Recommended Seating Capacity Maximum Load Capacity Electric Adapter Transformer Description For Children Ages 5 To 7 Years One Person Battery 6 VDC Rechargeable Initial Charge Time: 10 To 12 Hours Subsequent Charge Times: Under 15 Hours Quantity: 1 Thermal: Automatic Shut Down/Reset 1.6 MPH Forward (2.5 KM/Hr.) 1.6 MPH Reverse (2.5 KM/Hr.) 16.
. CHECK FOR DAMAGED PARTS. Before allowing this product to be used, carefully check that it will operate properly and perform its intended function. Check for damaged parts and any other conditions that may affect the operation of this product. Replace or repair damaged or worn parts immediately. 4. REPLACEMENT PARTS AND ACCESSORIES: When servicing, use only identical replacement parts. 5. MAINTAIN THIS PRODUCT WITH CARE. Keep this product clean and dry for better and safer performance. 6.
7. DO NOT ATTEMPT TO REMOVE DEBRIS OR FOREIGN MATERIAL CAUGHT IN THE MOVING PARTS OF THIS PRODUCT WHILE THE MOTORCYCLE’S THROTTLE PEDAL (2) IS IN THE “ON/DOWN” POSITION. Release pressure on the Throttle Pedal to turn off and stop the Motorcycle. 8. GROUND THE ELECTRIC ADAPTER TRANSFORMER OF THIS PRODUCT. The 6 Volt DC Adapter Transformer (10) for this product is equipped with a 2-Prong Plug and requires the use of a grounded, 3-Prong Adapter Plug (not included).
REQUIRED MINIMUM EXTENSION CORD GAUGE – 120 VOLT NAMEPLATE AMPERES (At Full Load) 0-5 5.1 - 8 8.1 - 12 12.1 - 15 15.1 - 20 EXTENSION CORD LENGTH 0 - 25 Feet 16 16 14 12 10 25 - 50 Feet 16 16 14 12 10 50 -100 Feet 16 14 12 10 10 100 – 150 Feet 12 10 - 150– 200 Feet 12 - FIGURE B soap and water and rinse with lemon juice and vinegar. If the fluid comes into contact with the eyes, flush with water for several minutes and contact a doctor immediately. Never burn the Battery, as it can explode in a fire.
19. WARNING: People with pacemakers should consult their physician(s) before being around this product. Operation of electrical equipment in close proximity to a heart pacemaker could cause interference or failure of the pacemaker. UNPACKING When unpacking, check to make sure all the parts shown on the Parts List (page 11) are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
FORWARD SWITCH INSTRUMENT PANEL (1) REVERSE SWITCH HORN BUTTON HANDLE BAR (6) HEAD LIGHT (3) SEAT (5) TAIL LIGHT (4) WHEEL (8) SAFETY WHEEL (7) THROTTLE PEDAL (2) FIGURE C ASSEMBLY INSTRUCTIONS CAUTION: THIS PRODUCT SHOULD BE ASSEMBLED ONLY BY AN ADULT. To Connect The Front End Chassis To The Frame: 1. With assistance, raise and hold the front end of the Motorcycle off the ground. 2. Align the two mounting holes in the Front End Chassis (11) with the mounting hole in the Frame (12).
BOLT (13) FRAME (12) FRONT END CHASSIS (11) BATTERY SUPPLY WIRE (15) FIGURE D WIRING HARNESS (16) NUT (14) To Charge The Battery: 1. THE INITIAL CHARGING TIME FOR THE BATTERY IS 10 TO 12 HOURS. The Battery for this product has been partially charged by the manufacturer, and therefore requires an initial charging time of only 10 to 12 hours. Do not exceed 12 hours initial charging time. THEREAFTER, each subsequent charging time for the Battery may take up to 15 HOURS.
FIGURE E BATTERY (9) OPERATING INSTRUCTIONS 1. CAUTION: The Motorcycle Toy may easily tip over if not ridden properly. Always make slow turns and avoid sharp turns. 2. Once seated on the Motorcycle Toy, select the desired speed direction (Forward or Reverse) on the Instrument Panel (1). (See Figure C.) 3. Make sure to firmly grip and hold the Handle Bar (6) with both hands. 4. Then, step on the Throttle Pedal (2) to move the Motorcycle in the pre-selected direction. 5.
INSPECTION, MAINTENANCE, AND CLEANING 1. NOTE: ALL INSPECTIONS, MAINTENANCE, AND CLEANING SHOULD BE PERFORMED ONLY BY AN ADULT. 2. CAUTION: Always make sure the Throttle Pedal (2) is in its “UP/OFF” position before performing any inspection, adjustments, maintenance, or cleaning. 3. BEFORE EACH USE, inspect the general condition of the Motorcycle.
