Installation Guide

ASSEMBLY INSTRUCTIONS
8.
9.
7
9
8
7a.
A
E
7b
6
6
7a
Align three holes in switch housing with three
holes in switch housing plate. [To re-attach
switch housing cap, proceed to Step 7b.]
Re-attach switch housing with three screws
previously removed (Step 2a, page 5).
Tighten all screws securely.
Align holes in switch housing cap with holes
at bottom of switch housing. Re-attach
switch housing cap with three screws
previously removed (Step 2b, page 5).
Tighten all screws securely.
Switch
Housing
Cap
Switch
Housing
7b.
A
Install bulbs (E).
CAUTION: When replacing bulbs,
please allow bulbs and glass shade to
cool down before touching.
A
A
Remove pull chain extension from fan pull chain
if you have not already done so. Slide pull
chains through corresponding holes in glass
shade (B). Align center hole in the glass shade
(B) with threaded rod and push up gently on
glass shade (B). Thread pull chains through
appropriate holes in finial plate (C) and center
pull chain through hole in finial (D). (Align fan
pull chain so that it does not rub against the light
bulbs when fan is in operation.) Tighten finial (D)
to secure glass shade (B) to light kit fitter (A).
IMPORTANT: Do not overtighten finial (D) as
glass may crack or break.
C
D
B
Switch
Housing
Plate
Switch
Housing
Lowes.com/harborbreeze