Installation Guide

9X - Scrows

1X - Nut

STAND

llllI

SCREWS & NUT

L KEY TO TIGHTENING

SCREWS

(D)

(S)

(N)

(E)

Step 1

Step 2

Step 3

Step 4

Step 5

Step 1 Put Both Left & Right Bar in centre Position.

Step 2 Put Center Bridge Bar Horizontal on Both Small Side Bars.

Step 3 Put bottom bracket parallel to the hole of center bridge and then insert screw into the hole.

Step 4 Put both pipes one by one horizontal on bracket in center position.

Step 5 Put top bracket on pipes and then tight screw from top.

At least Two Persons are required to assemble the Product .

PAGE 1
Step 1 At least Two Persons are required to assemble the Product . Step 2 Step 3 1X I STAND 2X Step 4 1X 2X ll llllI SCREWS & NUT (S) L KEY TO TIGHTENING SCREWS (N) 9X - Scrows 1X - Nut 1X (D) (E) Step 5 Step 1 Put Both Left & Right Bar in centre Position. Step 2 Put Center Bridge Bar Horizontal on Both Small Side Bars. Step 3 Put bottom bracket parallel to the hole of center bridge and then insert screw into the hole.
PAGE 2
MODEL # HPM2002A Product Dimensions : 61"X21"X57.25" Step 4 Step 5 Step 4 Then Put Both Side Bars in Vertical position & Screw both in bottom bracket.