HEBS2 Blaster User Guide
Contents HEBS2 Blaster I. Blaster Component II. Blaster Specification III. Equipment Instructions 1. Interface 2. Menu IV.
I.
II. Blaster Specification Blaster Component Usage Instructions TM HiTRONIC Appearance Wireless Blasting System can only be used with HiTRONIC TM Electronic Detonator. TM HiTRONIC Wireless Blasting System equipment can be safely operated at temperature ranging from -20℃ ~ +60℃.
III. Equipment Instructions (Interface) Interface 2 5 3 1 4 4 6 1) Binding Post : Connect detonators 2) RF Antenna : Unfold when longer radio range required. 3) Power LED : Power status LED 4) L,R Button : Left, Right buttons are used in blasting sequence, with LED indicator. 5) Power Button : Turn on/off the device. : Displays various information, offers touch interface for user control. : Charging port. Does not offer USB communication.
III. Equipment Instructions (MENU) Screen Saving Time : Set screen dimming Language : Select UI language System Time Setting : Adjust system time Intro Tap ‘Start’ button General Settings Change Password : Change system password Blaster & Repeater Mode : In this mode, the device waits for pairing request signal from Remote device. Remote Mode : Perform scanning for search nearby Blasters and Repeaters to pair.
IV. Operation Method Connecting (Open pit mine) ① Loading holes (No delay time yet) ② Hook‐up detonators on harness wire (trunk wire) by the detonating order. ③ Connect the harness wire to Logger, run circuit test on the Logger. ④ Transfer Blast plan from HiPlanner to Blaster ⑤ When blasting site is secured and ready for blast, progress blast sequence on blaster or remote via wireless. ⑥ Fire when ready. ⑦ Waiting for at least 5 minutes for safety.
IV. Operation Method Number of Detonators and Connecting Wire Resistance When : If Connecting Wire resistance is too high, communication may not work or misfire could occur. Solution : Adhere to the below table of Connecting Wire resistance per number of detonators. ※ Contact the maintenance if it is difficult to determine the possibility of detonation.
For a Class B digital device or peripheral, the instructions furnished the user shall include the following or similar statement, placed in a prominent location in the text of the manual: NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
