User's Manual

English _9
● OVERVIEW
CONTROL BOX NAME AND FUNCTION
Part Names Functions

POWER
Shows the power status.
` In a delayed boot state, the LED blinks until the system starts up.
b
REC
Shows the REC status.
` LED blinks during emergency recording.
c
RAID
Shows the RAID status.
` When the RAID is OK, the LED is on. The LED blinks when RAID is in a Degraded or Rebuilding
state. The LED is off when RAID is unused or in RAID Fail.

HDD ERROR
Shows HDD error.
` When HDD is checked, replaced, or there is RAID Fail, the LED illuminates.

EMERGENCY
Performs emergency recording.
` The REC LED blinks when recording is in progress. You can set an alarm occurrence to indicate
that emergency recording is on/off. For emergency recording buzzer setting, refer to
“Settings”. (page 28)
MAIN CONNECTORAUDIOPOWER



POWER
GPS
ALARM
REC
RAID
HDD ERROR
 b
c




Part Names Functions

ALARM
Shows the alarm status.

GPS
Shows GPS reception status.
` The LED is off before GPS reception is active. If the GPS reception is good, the LED illuminates.
If the GPS reception is poor, the LED blinks.

AUDIO
Outputs audio to the RCA jack.

MAIN
CONNECTOR
Connected to the main unit via the control box connecting cable.

POWER
As the switch is a push type, it is turned off when it is pushed. While it is on, if it is pressed
and held for 5 seconds, the system will stabilize and then turn off automatically.