User's Manual

M
` Refer to "Using Virtual Keyboard". (Page 26)
` If you select <OFF>, the input box will be inactive.
` If you select <hanwha-security.com>, the host name input box will be inactive.
• Quick Connect : Select whether or not to use.
To use the function, set to <Use> after connecting the NVR to a UPnP router.
M
` If canceled during Quick Connect configuration, it automatically switches to <Not Use> and saved.
` If you are setting a port that is already in use, the connection may not be established. Check the port setting of the router.
` The server name, manufacturing ID, and quick connect appear when <DDNS site> is selected as <hanwha-security.
com>.
To check Quick Connect status
A progress bar and its message appears for a Quick Connect.
• Quick Connect Success : Message for a successful connection.
• Invalid Network Configuration : Message appears if the network configuration is not valid. Check the
configuration.
• Please enable UPnP function of the router : Message appears if the router requires UPnP function
enabled.
• Failed to find the router : Message appears if the router is not found. Check the router's configurations.
• Please restart the router : Message appears if the router should be restarted.
DDNS Setting
DDNS is a short form of Dynamic Domain Naming System.
DNS (Domain Name System) is a service that routes a domain name consisting of user friendly characters (ex :
www.google.com) to an IP address consisting of numbers (64.233.189.104).
DDNS (Dynamic DNS) is a service that registers a domain name and the floating IP address with the DDNS
server so that the domain name can be routed to the IP address even if the IP is changed in a dynamic IP
system.
• Setting DDNS in the NVR
Set <Protocol Type> in the <Protocol> menu of the connected NVR to the following :
Ex) Protocol Type : TCP
Port (TCP) : 554, 555, 556, 557, 558
DDNS Site : hanwha-security.com
• DDNS Settings of the Router
Select the corresponding menu for the network transfer protocol of the router.
• Setting up UPnP of Router
Refer to the router's documentation to enable the UPnP function of the router.
Port Setting
• Device Port : Enter the connectable port number. Initially, <554> is set.
- TCP : It has better stability and lower speed when compared to UDP, and recommended for internet
environments.
• UDP Port : Initially, <8000~8159> is set. It increases / decreases by 160.
- UDP : It has less stability and faster speed when compared to TCP, and recommended for local area
network (LAN) environments.
• Multicast IP Address : User can directly input.
• Multicast TTL : Select from 0 ~ 255. Initial value for the TTL is set to <5>.
• HTTP Port : Enter the port number for the Web Viewer. Initially, it is set to <80>.
• Send SSL : Select this option to send SSL.
• Backup Bandwidth : Select the degree of backup bandwidth.
DDNS
If a remote user accesses the network, you can set whether or not to use DDNS and the site to be connected.
• DDNS Site : Specify the use of DDNS and select a site that you registered.
• Server Name : Provide the host name that you registered with the DDNS site.
• Product ID : Provide the user ID that you registered with the DDNS Site.
• Password : Provide the password that you registered with the DDNS site.
• Host Name: Enter the host name registered on the DDNS site.
• User Name: Enter the user name registered on the DDNS site.
English _45
● MENU SETUP