User's Manual

G sensor

This function sets events and alarms to be generated according to vehicle movement.

` The time of occurrence can be checked in the event log. (Page 29)

` After the email setting, G sensor event occurrences can be sent. (Page 47)

• G Sensor is used. : Checks whether G sensor is used or not.

• Sensitivity : Sets the sensitivity level (Low/Medium/High) for G sensor output. The higher the sensitivity level,

the more frequent the G sensor events.

• Alarm out Setup

If <All> was selected, both beep sound and alarm signal through rear side ports will output.

If <BEEP> was selected, a beep will sound.

Alarm signal will output through the alarm out port on the rear side when selected <1>, <2>, <3>, <4>, <5>

and <6>.

•

Alarm Duration : Sets the alarm duration for the alarm signal and beep sound.

` The G sensor event does not occur if the control box is not connected to the vehicle.

NETWORK CONFIGURATION

It provides networked monitoring of Live screen from a remote place, and supports mail forwarding function with

events. You can configure the network environment which enables such functions.

Interface

You can set the network connection route and protocol.

Setting a network connection

Sets the protocol and environment of the network.

• Network 1 (Camera) : Port recommended for camera connection, which receives a image from the camera.

• Network 2 (

Viewer) : Port recommended for connection with a network, web viewer.

• Network 3 (Wi-Fi) : Port for connecting to external Wi-Fi.

The Wi-Fi port is used for backup. (Up to 120Mbps is available.)

• Network 1 (Camera) / Network 2 (Viewer) / Network 3 (Wi-Fi) setup

IP Type : Select a network connection type.

IP Address, Subnet Mask, Gateway, DNS

<Static> : You can manually enter IP address, subnet mask, gateway and DNS.

<DHCP> : IP address, subnet mask and gateway values will be automatically set.

<PPPoE> : IP address, subnet mask and gateway values will be automatically set.

For Network 3 (Wi-Fi), the SSID is displayed above the IP address.

User ID, Password : If you set the connection mode to PPPoE, you need to enter "User ID" and

"Password" to register in PPPoE.

• Transfer bandwidth : Enter the maximum amount of upload data bandwidth.

Check the assigned setting in Connection Mode before entering your value.

` Up to 256Mbps is available for wired networks.

• Default Gateway : Set the basic gateway by using Network1 / Network2 / Network3 setup.

` You can manually input DNS of <DHCP> and <PPPoE> when it selected to <Manual>.

English _43

● MENU SETUP