User's Manual

M
` If the channel is set to <Covert1> or <Covert2> mode, the channel's sound is not hearable.
However, the channel's sound is recorded if its Audio setting is set to <ON>, even the sound is not heard in Live mode.
• Audio
- If set to <ON>, you can turn the audio of the channel ON/OFF on the Live screen.
- If set to <OFF>, the channel's audio is off on the Live screen and not recorded.
• Camera Name : Provide a camera Name.
` You can enter up to 15 characters including space.
Storage Device
You can check information on storage devices.
Device/Format
You can check storage devices and their capacity, usage as well as status.
HDD, USB (memory or HDD) can be connected as a storage device.
• Storage Status : Displays the working status of a storage device.
- Red : Displays the situation of video loss.
- Green : Displays the normal situation without video recording losses.
- Status
` Full BPS : Displays the current rate of recording.
` Current Loss Rate : Displays the current recording loss rate.
` Max Loss Amount : Displays the maximum amount of losses up until now.
` If loss is continuously generated, check the following.
For more information, refer to the "Troubleshooting". (page 82)
- When data is received due to a system malfunction (reset the video transmission volume of the camera)
- When there is a problem in HDD recording performance due to an HDD malfunction (check the HDD error or replace the
HDD)
• No. : You can check the designated number for the built-in HDD.
` If you want the find out about the location corresponding to the HDD number, refer to the <HDD Map>.
• Capacity : Displays the amount of storage device use and the full capacity.
• Usage : Designate the purpose of use for a storage device.
` If the state of use is in "Not Defined", format the HDD before use.
• Status : Displays the current working condition of a storage device.
For inspection or replacement of HDD alarms, please refer to "HDD Alarm Setting." (Page
38)
- Normal : It is displayed during normal operation.
- Inspection : Operating with partial problems.
- Replacement : It is displayed when you can no longer use it.
• Temperature : You can check the temperature of the HDD mounted in the NVR.
• Time : Displays the use time of an HDD.
• Format : Select a device and click on format after which a format confirmation window appears.
Click on the <OK> button to format the selected storage device.
J
` Formatting will delete all the recording data that has been saved. Be careful.
` While formatting is ongoing, you cannot record video.
` Do not remove a formatting device until it is finished.
` After installing an HDD, if the state of use of the HDD is "Not Defined", format the HDD before use. (If the warning message
persists after formatting, replace the HDD with a new one)
• HDD Map : You can check the location according to the assigned number for the HDDs installed inside.
` Refer to this when servicing or installing an additional HDD.
J
` Do not add or remove an HDD while NVR is running.
36_ menu setup
menu setup