User's Manual
10_ installation
installation
Please take note of the followings before using this product.
• Do not use the product outdoor.
• Do not spill water or liquid in the connection part of the product.
• Do not impose the system to excessive shock or force.
• Do not pull out the power plug forcefully.
• Do not disassemble the product on your own.
• Do not exceed the rated input/output range.
• Use a certified power cord only.
• For the product with an input ground, use a grounded power plug.
• Do not move the product using the HDD bracket handle on the front of the product as it may cause damage to the
HDD.
CHECKING THE INSTALLATION ENVIRONMENT
This product is a top-notch security device that is equipped
with a high-capacity HDD and other key circuit boards.
Note that an excessive internal temperature of the product may
cause a system failure or a shortened product life (see the right
figure). Keep in mind the following instructions before installing
the product.
HOW TO INSTALL THE BRACKET
1. After removing the product from the box, disconnect
the bottom bracket by removing the bracket assembly
screws (10 pieces), as shown in the figure.
2. Place the floor bracket on a flat surface and fasten it
with the mounting screws (12 pieces) included in the
product, as shown in the figure.
3. Reassemble the main unit and floor bracket.
`
This is a shock absorber to protect the HDD from vehicle
vibration.
One Year: 24HR X 365 DAY =8,760 HR
Temperature
Unit: ºC
Life (Unit: HOURS)
[Figure 1]
HOW TO INSTALL THE CONTROL BOX
Assemble mounting screws and install the camera on a
wall/floor/ceiling as shown in the figure.
HOW TO CONNECT THE CONTROL BOX
Connect to the main unit via the control box connection cable.
HDD ADDITION
Make sure to unplug the power cord from the wall outlet to prevent possible electric shock, injury or product damage.
Please consult your provider for further information on HDD installation since improper installation or settings may
damage the product.
` Number of HDDs supported : Up to 2 HDDs supported
` Make sure to unplug the power cord from the wall outlet before proceeding with the installation.
J
` Cautions for data loss (HDD care)
Please pay attention so that the data inside the HDD is not damaged.
Before adding a HDD, please check the compatibility with this product.
HDD is vulnerable to malfunction due to its sensitive nature especially against shock when operating.
Please ensure that the HDD is free from such shock.
We are not liable for any damage to the HDD incurred by user's carelessness or miss use.
` Cases might cause damage to HDD or recorded data
To minimize the risk of data loss from a damaged HDD, please backup data as often as possible.
If exposed to shock when disassembling or installing, data stored in the hard disk may be damaged.
A sudden power failure or turning off the product while in HDD operation may damage the hard disk drive.
HDD or files stored inside may be damaged if the main body is moved or impacted during the HDD operation.
USB 2.0
USB 3.0
AUDIO
POWER
REC
ALARM
VGA
GPS ANT
HDD1
HDD2
HDMI
USB 2.0
Screw for bracket
assembly
Mounting screws
Mounting screws
CONTROL BOX
RS-232C
ALARM BLOCK
CONSOLE
DC 9V~36V
VIEWER CAMERA
WIFI ANT2 WIFI ANT1
PoE1 PoE2 PoE3 PoE4
TROL B
CONTROL BOX
CO
NTR
O
L B
OX
Control box