User's Manual

29
Webthru SWC 306 User’s Guide
are the same as seen on ‘Video
Configuration’ page.
(2) Pan Tilt Function
Administrator defines whether to
utilize pan/tilt control function or
not.
(3) Zoom Function
Administrator defines whether to utilize zoom control function or not.
(4) Pan Reverse Mode Function
This is to set command reverse direction against to right and left direction control arrows. This function is
useful when PT driver is installed upside down.
(5) Tilt Reverse Mode Function
This is to set command reverse direction against to up and down direction control arrows. This function is
useful when PT driver is installed upside down.
(6) Select Serial Port
It is to select a useable serial port as the character of pan/tilt/zoom control receiver.
It is to select a serial port between ‘Serial #1’ and ‘Serial #2’ with which a pan/tilt/zoom control receiver is
connected to Webthru. Serial #1 is RS232C interface and Serial #2 is RS422/RS485 interface.
(7) Serial Port Base Address
This menu identifies the base address for a video channel and a pan/tilt/zoom (P/T/Z) control receiver.
Webthru SWC 306 can support up to six P/T/Z devices for six separate channels when Serial #2 (RS485 Half-
Duplex) is enabled. The “Serial Port Base Address” identifies each P/T/Z device to each channel. Select a
channel to configure and change the “Serial Port Base Address” to correspond with the channel number.
10) Serial Port Configuration
This page is to select a communication
protocol among listed ones or to set
control parameters manually for each
serial port.
(1) Serial Port Selection
Administrator selects a serial port to configure. Webthru SWC 306 has two serial ports. Serial #1 is a RS232C
interface port, and Serial #2 is a RS485/RS422 interface port.
(2) Select Attached Device
Administrator selects a communication protocol that an attached external device satisfies among already listed
protocols. Samsung Techwin has listed protocols of Philips, Pelco (P and D), Sensormatic, Video Technical
(VTP 4x), LG (GAC-PT2), Sony (EVI-D3x), Surveyor (PT360 and TransitRCM), Sungjin (SJ3728R1),
Kukjae (KRS-3200), Serim (SRP-PT1), Mitsubishi (CIT7300), and Samsung Techwin (SRX100B).
Administrator may utilize any pan/tilt mechanism that satisfies already listed protocols.