User's Manual

12
· English
LED status
LED indicator shows operational status with colors.
Refer to table below for detailed meaning of the LED indicator.
Color Status
Red Booting up
Red Blinking Booting completed / Establishing network connection
Yellow Enabling Wi-Fi Direct
Blue Blinking Connecting to the network.
Blue Local connection established
Green Connection to server completed / Normal operation
Purple Updating firmware
Network connection
In a location with a strong Wi-Fi signal and no interference, use Wi-Fi
communication.
Assembling
1. Use a drill on the marked positions, and drill holes
to a depth of 3 cm. Clean the holes after drilling.
J
` It is recommended to use a drill bit (Ø5) that is suitable
for the wall material.
` Be careful not to get injured while drilling.
2. Insert an anchor for the two holes. Fully insert
the anchors by gently tapping the anchor
head with a hammer or rubber mallet.
3. Match the camera to the holes on the door
and fasten the screw.
4. Insert the Deco case into the camera front.
5. Tighten the screws to combine the casing.
RESET
RESET