Manual

network configuration
20_
network configuration
How to configure an IP address automatically using [Auto Set]:
1. Launch the IP Installer on the PC for IP configuration.
2. Click the [Search] button. A list of network devices using IP
addresses located at the same router is displayed.
3. Check the MAC address information and select a device to
configure.
4. Click on the [Auto Set] button.
[Auto Setting] window with IP Address, Subnet Mask and
Gateway entered pops up.
5. Type the password authentication number for camera
access and click the [OK] button. Configuration is now
complete.
M
 The password for camera access is identical to the “admin”
login password.
Default value is “4321”.
 VNP Port is to control video transmission.
Default value is “4520”.
Notice for Installer Setup
1. If two or more network cameras are connected to the router, you should configure the IP and port-
related parts differently.
Category Camera #1 Camera #2
IP related settings
IP Address
Subnet Mask
Gateway
192.168.1.100
255.255.255.0
192.168.1.1
192.168.1.101
255.255.255.0
192.168.1.1
Port related settings
HTTP Port
VNP Port
8080
4520
8081
4521
2. If the <HTTP Port> is set other than 80, you must provide the <Port> number in the address bar of
the Internet browser before you can access the camera
ex) http://IP address : HTTP Port  http://192.168.1.100:8080)