User's Manual

6 96 8
BEFORE CONTACTING SERVICE CENTER
¶U Batteries need replacing. ¶U Replace batteries with new ones
¶U AC Power Adapter ¶U Connect AC Power Adapter.
is not connected.
¶U Batteries need replacing ¶UReplace batteries with new ones
¶UCamera has shut off automatically ¶U Power on
¶UThe card is taken off before the ¶U Do not remove the memorycard
image is saved in the memorycard. while you save the image.
¶U The adapter jack is off because it loosens. ¶U Plug in the adapter jack again.
¶UExternal temperature is too cold. ¶UKeep batteries at the correct
t e m p e r a t u r e .
¶U The camera has old and ¶UReplace all batteries and
new batteries insert new ones
¶UCF Card is not inserted ¶UInsert CF Card
¶U The memory card has not been inifialised. ¶UI n i t i a l i s e
¶UMemory card are almost drained. ¶U Insert new CF Card from manufacturer
¶U The power has not been switched on. ¶UPower on.
¶UThe batteries are weak. ¶UReplace batteries with new ones
¶UThe camera is not set to ¶UShooting mode
shooting mode.
¶U Select the macro mode in case it is
¶UYou select the wrong shot mode. within 80 cm and select the
general mode in case it is over 80cm.
¶UThe camera is flash off ¶UThe flash off mode is canceled.
¶UThe wrong date/time is displayed ¶U Select the appropriate number in
or saved as the basic number. MENU mode.[Refer to the selecting
DATE/TIME on the page 21.]
Before contacting service center (please check the following)
Warning indicator
The power is
not turned on
If the power
will not turn on.
Battery power
is drained
quickly.
Camera does not
take pictures
when pressing
the Shutter
b u t t o n .
The flash mode
does not work.
The focus cannot
be adjusted.
The wrong date
/time is displayed.
¶U No memorycard ¶U Insert the memorycard.
¶U The card cannot be read. ¶U Insert the memorycard again.
¶UThe capacity for shot in ¶UReplace the card with the
memorycard is lacking. new one or use it after you
erase the locked image.
NOTE IN USING
¢ Ú Maintenance
°§ To clear the Lens or LCD Status panel, a soft brush should be used. If this
does not work lens-cleaning paper with lens cleaning fluid can be used.
°§ Clean the camera with a soft cloth or a mild detergent. It may cause the
deterioration, deformation or falling off the paint.
°§ The LCD moniter can be damaged very easily, please ensure that it does
not come into contact with any sharp impact.
¢ Ú Do not attempt to disassemble or modify the device by yourself.
°§ The warning indicator displayed on the shot information indication is as follows.
¶UPlease turn the power off and
turn it on again.If it happens
again, please ask for the repair
service to the near Samsung
service center.
¶UThe camera indicates abnormal
operation.
warning
indicator
warning contents treatment
Symptom
Cause
Steps
-Digimax210SE(48~71) 00.10.24 8:34 AM D‰¿Ã¡ˆ68