Operation Manual

Structures
How to set up the model coin
Power on the tester and open the gate, you will see there’s a coin
accepter(see photo below) and LED indicator⑦ lighting continuously.
Press set button⑤ 2 seconds then release, the left top LED
indicator⑦ turns from red to green. Press the set button⑤ 2 seconds
again and release, the LED⑦ turns from green to red and flashes, now
it enters into coin setting state, please put model coins into the coin slot
20 times(Recommend to put into coins of different years with different
versions, coins can be fast or slow speed so as to simulate the normal
use) until the coin slot does not accept coin anymore. When it’s finished,
the indicator lamp remain constantly lighting and the model coin setting
is success.
1. Case Locker
2. Mounting Hole
3. Coin Accepter
4. Main Board
5. Sensor Module
6. Payment Module
7. Nozzle Hole