User's Manual

If you try to make an outgoing call while outgoing call lock is enabled, then you will hear
warning tone after dial time-out as a indication of entering the LOCK code.
You should enter LOCK code to make an outgoing call. LOCK code is composed of 4 digits
and the initial setting is "0000". Outgoing Call Lock feature is disabled as a factory setting
1.Pick up the handset.
2.Press <*( ) >, <*( ) > and <6>.
NOTE : If the code is correct, it sounds confirmation beep.
If not, it returns to the stand by mode with error beep.
4.Press <*( ) > to set outgoing call restrict or Press <#( ) > to release outgoing call
restrict.
NOTE : If someone tries to make a call when outgoing call restriction is set,
it sounds outgoing call restriction tone and howler tone.
Used when you wish to change the lock code of the terminal. The programmed lock code
prevents the terminal from being operational to any other people without your permission.
This feature can be disabled and enabled through simple keypad number code entry.
When you first buy the phone, the lock number is 0000.
1.Pick up the handset.
2.Press <*( ) >, <*( ) > and <7>.
3.Press 4 digits Look Code Number(The default lock code is preset to 0000 at the factory).
4.6 Outgoing Calls Lock
4.7 Lock code
NOTE : If the code is correct, it will confirm with a tone.
If the code is incorrect, it returns to the standby mode with error beep.
4.Press 4 digits new Lock Code Number. It sounds confirmation beep.
5.Press 4 digits new Lock Code Number again. If it is different from the new Lock
code you entered in the beginning, it returns to the standby mode with error tone.
6.Press <*( ) > to store new Lock Code. If you press other key, it returns to the standby
mode with error tone.
NOTE : If it is correct, it sounds confirmation beep.
3.Press 4 digits Lock Code Number. (The default lock code is preset to 0000 at the factory.)