User Manual

User Manual
48 / 72
values of at most 4 measurement items that are turned on last.
1. Press the [Meas] button on the front panel to enter the Measure function menu.
2. Press the Statistics softkey to select ON.
To Make All Measurement
All measurement could measure all parameters of the current measurement source and display the
results on the screen.
Do the following steps to make all parameters measurement.
1. Press the [Meas] button on the front panel to enter the MEASURE function menu.
2. Press the All Measure softkey to select ON.
3. Press the Source softkey to select the measure source (CH1~CH2).
No.
Type
Comments
1
Frequency
The reciprocal of the period.
2
Period
The time between two consecutive threshold points of the same polarity edge.
3
Average
The arithmetic mean of the entire waveform or selected area.
4
Pk-Pk
The voltage value from the peak to the lowest point of the waveform.
5
RMS
That is a valid value. According to the energy converted by the AC signal in one cycle, the DC
voltage corresponding to the equivalent energy is the root mean square value.
6
Period Rms
The root mean square value of the signal within 1 cycle.
7
Min
The most negative peak voltage measured over the entire waveform.
8
Max
The most positive peak voltage measured over the entire waveform.
9
RiseTime
Measure the time between 10% and 90% of the first rising edge of the waveform.
10
FallTime
Measure the time between 90% and 10% of the first falling edge of the waveform.