User's Manual
Important Safety Instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer‘s instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including ampliers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two
blades with one wider than the other.
A grounding type plug has two blades and a third grounding prong. The wide blade or the third
prong are provided for your safety. If the provided plug does not t into your outlet, consult an
electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus.
11. Only use attachments/accessories specied by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table specied by the manufacturer, or sold with the
apparatus. When a cart is used use caution when moving the cart/apparatus combination to avoid
injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Refer all servicing to qualied service personnel. Servicing is required when the apparatus has
been damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does
not operate normally, or has been dropped.
15. WARNING: To reduce the risk of re or electric shock, this apparatus should not be exposed to rain
or moisture and objects lled with liquids, such as vases, should not be placed on this apparatus.
16. To completely disconnect this equipment from the mains, disconnect the power supply cord plug
from the receptacle.
17. The mains plug of the power supply cord shall remain readily operable.
Warning
Unpacking
Disposal
Packaging material
Loudspeakers
Sleep and low-power modes
Remote control battery
RISK OF ELECTRIC SHOCK! DO NOT OPEN!
To reduce the risk of electric shock, do not remove the back panel and do not expose the apparatus to rain
or moisture. No user serviceable parts inside. Refer servicing to qualied personnel.
After unpacking, make sure the system is complete and check the device and all accessories for transport
damage. Transport damage may be expected if the packaging is severely harmed. Do not attempt to com-
mission a damaged device. If the contents are incomplete or damaged, please contact your Dynaudio Xeo
distributor. Distributor addresses can be found in the Internet at www.dynaudio.com.
This symbol on the product or on its packaging indicates that this product shall not be
treated as household waste. Instead it shall be handed over to the applicable collection
point for the recycling of electrical and electronic equipment. By ensuring this product
is disposed of correctly, you will help prevent potential negative consequences for the
environment and human health, which could otherwise be caused by inappropriate
waste handling of this product.
The recycling of materials will help to conserve natural resources. For more detailed
information about recycling of this product, please contact your local city oce, your
household waste disposal service or the shop where you purchased the product.
Disposal of Old Electrical & Electronic Equipment (Applicable in European countries with separate
collection systems)
The packaging has been designed so that it may be reused if it was not damaged during transport. Do not
throw away the packaging and use the original packaging for all further transport.
WARNING: Dangerous electrical voltage
If the loudspeakers are connected to the mains voltage, a dangerous electrical voltage is present inside the
speakers.
• Never open the loudspeaker housing.
• Do not operate defective loudspeakers and disconnect defective loudspeakers from the mains voltage.
Please contact your Dynaudio Xeo distributor if you have any problems. Distributor addresses can be
found in the Internet at www.dynaudio.com.
• Use the supplied power cable to connect the loudspeakers to the mains voltage. Make sure that the
power supply cable is not damaged; exchange it for a new one if it has been damaged.
WARNING
This device complies with Part 15 of the FCC Rules. Its operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Cet appareil est conforme à la section 15 des réglementations de la FCC. Le fonctionnement de l’appareil est
sujetaux deux conditions suivantes : (1) cet appareil ne doit pas provoquer d’interférences néfastes, et (2) cet
appareil doit tolérer les interférences reçues, y compris celles qui risquent de provoquer un fonctionnement
indésirable.
Note: This product has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This product generates, uses, and can radiate radio fre- quency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this product does cause harmful interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Please take attention that changes or modication not expressly approved by the party responsible for compli-
ance could void the user’s authority to operate the equipment.
IC NOTICE
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the follo-
wing two conditions: (1) this device may not cause interference, and (2) this device must accept any interferen-
ce, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d‘Industrie Canada applicables aux appareils radioexempts de
licence. L‘exploitation est autorisée aux deux conditions suivantes : (1) l‘appareil ne doit pas produire de
brouillage, et (2) l‘utilisateur de l‘appareil doit accepter tout brouillage radioélectrique subi, même si le brouilla-
ge est susceptible d‘en compromettre le fonctionnement.
MPE Reminding
This equipment should be installed and operated with a minimum distance 20 cm between the radiator and
your body.
Cet équipement doit être installé et utilisé à une distance minimale de 20 cm entre le radiateur et votre corps.
(i) The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for
harmful interference to co-channel mobile satellite systems;
(ii) The maximum antenna gain permitted for devices in the bands 5250-5350 MHz and 5470-5725 MHz
shall comply with the e.i.r.p. limit; and
(iii) The maximum antenna gain permitted for devices in the band 5725-5825 MHz shall comply with the
e.i.r.p. limits specied for point-to-point and non point- to-point operation as appropriate.
(i) Toutappareildestinéàlabande5150-5250MHzdevraêtreexclusivementutiliséenintérieurande
réduire les risques de pertuarbations électromagné- tiques gênantes sur les systèmes de satellite
mobile dans un même canal.
(ii) Les radars à forte puissance sont désignés comme les utilisateurs principaux (c’est-à-dire qu’ils sont
prioritaires) des bandes 5250-5350 MHz et
(iii) 5650-5850 MHz. Ils peuvent provoquer des perturbations électromagnétiques sur les appareils de type
LELAN (réseau de communication local sans licence) ou les endommager.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and
maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio inter-
ference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that necessary for successful communication.
Conformément à la réglementation d’Industrie Canada, le présent émetteur radio peut fonctionner avec
une antenne d’un gain maximal (ou inférieur) approuvé pour l’émetteur par Industrie Canada. Dans le but
de réduire les risques de brouillage radioélectrique à l’intention des autres utilisateurs, il faut choisir le type
d’antenne et son gain de sorte que la puissance isotrioe rayonnée équivalente (p.i.r.e.) ne dépasse pas
l’intensité nécessaire à l’établissement d’une communication satisfaisante.
The USB socket on rearplate marked with label ‘Service’ is for rmware upgrade purpose only.
This product can be used in all EU regions for indoor use with no further restrictions.
This product complies with the Directive 1999/5/EC.
Relevant DoC for this product can be found in our Dynaudio homepage via the link:
http://www.dynaudio.com/support/manuals/
Sleep mode is available by pressing [OFF] button on remote or if there is no audio signal for 20 minutes. In
this mode the wireless network will be active and all connected units will remain synchronized.
• Sleep mode power consumption is <2W
Low power standby mode is available by press-and-hold OFF button on remote for 5 seconds. In this mode
the wireless network is disabled and there is no connection between the speakers.
• Low-power standby mode power consumption is <0.5W
Note: The batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as
sunshine, re or the like.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
The remote control supplied with a coin/button cell battery. If the coin/button cell battery is swallowed,
it can cause severe internal burns in just 2 hours and can lead to death.
Keep new and used batteries away from children. If the battery compartment does not close securely,
stop using the product and keep it away from children.
If you think batteries might have been swallowed or placed inside any part of the body, seek immediate
medical attention.
DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD!
Safety information
Safety information
Reminding
su1226