User Manual

WiFi Protected Setup (WPS)
Your home network router must have a WPS button in order for this to work. To determine
whether your router has WPS consult the manual of the router or your internet provider in case
the router was provided by them.
1. Press the WPS button on your router (model dependent). Note that the “WPS” symbol can
vary.
2. Select input “WiFi” on the MSU either by the Input button on the MSU or the Remote
Control. The Sound unit display should show “WiFi”
3. Press in the middle of the Menu/Select wheel on the MSU to enter the Menu and go to
System Setup (“SysSetup”). Choose the “WiFi” and then select “WPS”. The MSU will start
connecting to the home network. The display will blink “Link” doing the process.
Note: This step can also be completed on the remote control by pressing and holding
“Radio Down” button for three seconds.
4. When “WiFi N” is displayed, complete the process by pressing return bottom to come back
to the mail menu and turn off the sound unit and on again.
5. The sound unit is now connected to your home network and you can stream and play
music from your phone or tablet or steam music from the internet.
Menu SysSetup WiFi WPS
Important! The Sound Unit cannot store the Network
settings in this mode