User Manual

Setup and use of the Radio (FM and DAB)
Scan DAB stations
Follow the instructions below to scan for DAB stations
1. Change input to “DAB”
2. Press and hold Radio Up on the remote for 3 seconds. The MSU will scan for all DAB
stations available (Memory Max 30 stations)
3. When the MSU is done scanning pressing Radio Up will rearrange the stations in to
ascending order.
4. Toggle between the stations afterwards by using the Radio Up/Down button on the
remote.
Store FM presets
Follow the instructions below to set up the presets channels.
There are 10 presets channels which a given FM station can be saved to.
5. Change input to “FM”
6. Press and hold Radio Up/Down on the remote for 3 seconds. The MSU will search for the
next radio station.
7. When the MSU has found a radio station it will ask whether the station should be stored or
not.
o Store -> Use the wheel to change the presets which to the station should be stored.
Click the “Menu/Select” button on the MSU to confirm.
o Not store -> Use the Radio Up/Down button again to continue the search or wait 5
seconds until the frequency is shown again.
8. Repeat step 2-3 for each radio station that is to be stored.
Tip: If the frequencies of the wanted FM stations are known the Tuner menu can be used instead:
1. Change input to “FM”
2. Use the Menu/Select to enter the Tuner setup.
3. Go to “Frequency” and use the wheel to find the FM stations which you want to store.
4. Go to “Save” and press on the menu/select again to confirm.
5. Use the wheel to change the preset which the frequency should be saved to. Use the
menu/select button to confirm
6. Repeat step 3-5 for each radio station that is to be stored.
Daily FM use
Use the “Radio Up” and “Radio Down” button on the remote control to change between the
different stored presets.