User's Manual
883351
Install Instructions For:
SB335
This device complies with Part
15
of
the FCC Rules I Industry Canada licence-exempt RSS standard(s). Operation
is
subject
to
the
following
two
conditions:
(1)
this device may not cause harmful interference, and
(2)
this device must accept any interference
received, including interference that may cause undesired operation.
Le
present appareil est conforms aux CNR d'lndustrie Canada applicables aux appareils radio exempts
de
licence. L'exploitation
est autorisee aux deux conditions suivantes :
(1)
l'appareil ne doit pas produire
de
brouillage, et
(2)
l'utilisateur
de
l'appareil doit
accepter tout brouillage radioelectrique subi, meme
si
le
brouillage est susceptible d'en compromettre
le
fonctionnement.
Changes
or
modifications not expressly approved
by
the party responsible for compliance could void the user's authority
to
operate
the equipment.
This equipment has been tested and found
to
comply with the limits for a Class B digital device, pursuant
to
part 15
of
the FCC
Rules. These limits are designed
to
provide reasonable protection against harmful interference
in
a residential installation. This equip-
ment generates uses and can radiate radio frequency energy and, if not installed and used
in
accordance with the instructions, may
cause harmful interference
to
radio communications. However, there
is
no guarantee that interference will not
occur
in
a particular
installation. If this equipment does cause harmful interference
to
radio or television reception, which can be determined
by
turning
the equipment off and on, the user
is
encouraged
to
try
to
correct the interference by one
or
more
of
the following measures:
-Reorient
or
relocate the receiving antenna.
-Increase
the separation between the equipment and receiver.
-Connect
the equipment into an outlet on a circuit different from that
to
which the receiver
is
connected.
-Consult
the dealer
or
an experienced radio!TV technician for help.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna
of
a type and maximum (or lesser) gain
approved for the transmitter
by
Industry Canada.
To
reduce potential radio interference
to
other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (e.i.r.p.)
is
not more than that necessary for successful commu-
nication.
Conformement
a
Ia
reglementation d'lndustrie Canada,
le
present emetteur radio peut fonctionner avec une antenna
d'un
type et
d'un
gain maximal
(ou
inferieur) approuve pour l'emetteur par Industria Canada. Dans
le
but
de
reduire les risques
de
brouillage
radioelectrique
a !'intention des autres utilisateurs,
il
faut choisir
le
type d'antenne et son gain
de
sorte que
Ia
puissance isotrope
rayonnee equivalents (p.i.r.e.) ne depasse pas l'intensite necessaire
a l'etablissement
d'une
communication satisfaisante.