User's Manual

883351 ~~~!:II Instructions For:
Standby and sleep settings
There are two modes the SB335 can operate in; Standby and Sleep. Setting the SB335 in the standby mode disables the auto-on
input signal sensing.
In this mode the SB335 can only be turned on by pressing the Volume control On/Off switch or through RS232
control.
Setting the SB335
in the sleep mode enables auto-on input signal sensing and will turn the SB335 on when there is a signal present
and will automatically turn off when there
is no signal for 5-7 minutes.
Note: The SB335 goes into standby mode 5 minutes after it stops sensing a signal provided the amp is set to standby mode.
The SB335 will be switched into networked sleep mode
in 5 minutes after it stops sensing a Bluetooth or wired audio signal
provided the
amp is set in sleep mode.
Setting the operating mode:
1 . With the on/off switch in the off position (Red LED).
2. Press and hold the on/off switch for 10 seconds or until the LED starts blinking for 3 seconds.
3. If it blinks Blue it
is in Sleep mode
If it blinks Green it
is in Standby mode.
4. To change the mode repeat step 2.
LED mode guide
Standby: RED
Power on/No signal: White
Analog/PCM: Green
Dolby: Purple
Bluetooth: Blue
Bluetooth pairing: White blinking
IR learning mode: Purple blinking
Sleep: Blue blinking
Standby: Green Blinking
Note:
1 . The power consumption of the product in networked standby is less than 3W.