User's Manual

883351 ~~~!:II Instructions For:
2. To use the internal SB335
crossover set to 120Hz set
dip switch 1 to the up (Sub)
position.
3. To use an external Sub
crossover set dip switch 1 to
the down (line) position.
Connecting Your Wired Audio Source
1 . For digital connections
connect
an optical cable
from your source to the
optical input
on the SB335.
Set dip switch 6
in the
down position.
~------------~
2. For analog connections
connect a cable
from your
analog source to the
analog input using a stereo
1 /8"mini-jack.
Set dip
switch 6
in the up position.
Connecting Power to the 58335 Controlling volume using a TV remote
~
0 POWER
INPUT
DC32V=3.75A
.~ ~~.
0
1 . Connect the 32v power
supply
barrel connector to
the power input
on the
SB335.
G
4. Press and hold the on/off
button on the SB335 until it
starts blinking purple
(approximately 5 sec).
r---'
~ POWER
INPUT
32V=3.75A
~~~~
~
1. Connect the 1/8" mini plug
from the IR receiver to the
External IR port on the
SB335.
Flat Panel Display
IR Receiver-Q
~
5. Point the lV remote at the
IR receiver and press the
volume up button 3 times.
The purple LED will blink 3
times rapidly.
/
Rat Panel Display
1--.....
2. Position theIR receiver on
a surface that faces out into
the area you will be using the
remote control. Fasten the
IR receiver with the supplied
two-sided tape disk.
Rat Panel Display
IR Receiver-Q
' j>
~
6. Repeat step 5 with the
volume down button. The
purple LED will blink 3 times
rapidly.
ONIOFF ~
£/ @y
III
DOLBY.
DIGITAL (}
3. Turn the SB335 on by
pressing the on/off button.
The LED will turn white
when on.
7. Repeat step 5 with the
mute button.
The purple
LED will blink 3 times
rapidly
then turn solid
white. The amp is now
programmed
and will
respond to the remote
control volume
commands.