User's Manual

SET UP CONSIDERATIONS

Your wireless transmitter controller and the wireless receiver built in to your furniture feature sophisticated design to

maximize the range in a typical environment to a line of sight range of thirty feet. Trying to extend the range beyond

this or use in a situation that is not line of sight greatly increases the odds of poor performance. Avoid placing either the

transmitter controller or furniture in an area that would block wireless signals. Some environments, such as masonry or

steel stud walls, can create issues that can usually be corrected by adjusting the transmitter controller antennas or the

placement of the transmitter controller.

For Analog line-level input connections,

use high-quality RCA cables that feature

low impedance, double shielding, and

gold-plated connectors. Use similar quality

RCA connections for the Digital Coax

connections and high-quality Toslink cables

for the Digital Optical connections. Use the

provided setup poster for a fast and easily

visible reference tool.

SET UP AND CONNECTIONS

1. Connect to power source.

(a) Plug in furniture to AC power. Furniture can

operate on AC voltage from/100-240v at 50 or 60Hz.

if necessary use the appropriate plug adapter for

your location.

2. Connect sources to transmitter controller.

(b) Items that typically have high use, such as

cable or satellite receivers or DVD players should

use digital connections whenever possible. Please

note that up to four inputs may be used at any time.

The inputs for both analog (red and white RCA

connectors) and digital (orange RCA connectors for

coax and black Toslink for optical) connections are

numbered 1 through 4.

Input priority-If you use Digital input #1, do not

connect a device to Analog Input #1 and so forth.

Your transmitter controller will not be damaged if

you do so, but the advanced software will choose

and prioritize the Digital input when it detects a

signal, which could prevent you from being able to

hear the analog item if it is connected to an input

that is the same number as a Digital input.

3. Connect wireless transmitter controller to

power. (c)

4. Put the two included AA batteries in

remote. (d)