User's Manual

54
Applied Connection
How to Adjust monitor Angle
Connection to Computer
Basic Connection
1. Use 220 V or 110 V. (Free Voltage)
2. Connect monitor and computer via Signal cable (See figure
)
3. Power on the monitor and computer.
1. Connect the adapter to "12V DC" input terminal.
2. Connect the computer cable to PC1.
3. Connect video (V1) connection cable or SVHS (V2) connection cable to
DVD, VCR or camcorder.
4. Connect audio output (computer, DVD, VCR or camcorder) to Audio In (L),
Audio In (R) or Audio In (Stereo).
5. Connect headphone or earphone to H-Phone terminal.
6. Connect antenna or CATV connection cable to "Antenna" terminal.
Port for 12V DC
cable from DC
adapter.
Port for Signal cable
from Signal Source.
General
For Macintosh
In Usinga dapter.
Adapter for Macintosh (Optional)
Refer to the table on the rear side of
the optional Macintosh adapter and
adjust DIP switch by the resolution of
the monitor.