Installation Instructions / Warranty Talis S 32040XX1 Talis S 32240XX1
32040XX1 32240XX1 Technical Information Installation Considerations Recommended water pressure 14.7 - 72.5 psi Max. water pressure 145 psi Recommended hot water temp. 120� - 140� F* Max. hot water temp 176�F* Hole size in mounting surface 1-1/4" Max. mounting surface depth 1 5/8" Flow rate – lavatory 1.5 gpm Flow rate – bidet 2.2 gpm Cartridge with high temperature limit stop 3/8" supply hoses • For best results, Hansgrohe recommends that this unit be installed by a licensed, professional plumber.
Installation Flush the hot and cold supplies thoroughly before installing the faucet. Place the faucet and sealing washer on the mounting surface. If the mounting surface is less than 3/16” thick, trim the sealing washer so that it is even with the bottom of the mounting surface. Install the slide washer and collar nut. Tighten the collar nut by hand. Connect the supply hoses to the hot and cold stops. Use two wrenches, as shown in the diagram, to prevent hose twisting.
Set the High Temperature Limit Stop (optional) Use a 4 mm Allen wrench to push the screw cover into the handle. Use the 4mm Allen wrench to loosen the handle screw 4 complete revolutions. Remove the handle. Retrieve the screw cover. Remove the flange. Remove the handle screw. Remove the high temperature limit stop. Replace the high temperature limit stop so that the pin on the cartridge is in the desired slot on the limit stop.
Install the pop-up drain Remove the plunger assembly. Unscrew the drain outlet flange from the tee. Unscrew the tailpiece from the tee. Wrap the threads with Teflon tape and replace. Install the white, flexible sealing gasket to the flange. Place it in the sink outlet. Install the black mack gasket, white friction ring and retainer nut on the flange. Do not tighten the nut against the bottom of the sink at this time. Thread the tee and tailpiece to the flange. The pivot must face the faucet.
User Instructions Pivot the handle up to turn the water on, down to turn the water off. Pivot the handle to the left for warmer water, to the right for colder water. Replacement Parts 2 10 1.1 3 1 4 11 5 9 6 7 8 1 1.1 2 3 4 5 6 7 8 9 10 11 handle screw cover flange nut cartridge cpl. seal aerator cpl.
Cleaning Recommendation for Hansgrohe Products Modern lavatory faucets, kitchen faucets, and showers consist of very different materials to comply with the needs of the market with regard to design and functionality. To avoid damage and returns, it is necessary to consider certain criteria when cleaning.
THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR: A. Conditions, malfunctions or damage not resulting from defects in material or workmanship. B. Conditions, malfunctions or damage resulting from (1) normal wear and tear, improper installation, improper maintenance, misuse, abuse, negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or “norinse” cleaning products, or the use of the product in any manner contrary to the product instructions.
