ELECTRIC HEATER Model Number: 9711053 ASSEMBLE & OPERATION INSTRUCTIONS Please read carefully and save these instructions.
Warning THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE. The supplier will not be liable for any damages caused by failure to follow these instructions. IMPORTANT SAFETY INSTRUCTIONS PLEASE READ CAREFULLY - The infrared heater is designed for safe operation. Nevertheless, installation, maintenance and operation of the heater can be dangerous.
17. Do not use near or in the immediate vicinity of a bath or swimming pool or any source of water. Never immerse unit, cord or plug in water or any other liquid. 18. This heater is not intended for use in bathrooms, laundry rooms and similar indoor locations; never locate the heater where it may fall into a bathtub, sink or other water container. 19. Do not leave the appliance unattended when in use. Always unplug the heater when not in use. 20.
ASSEMBLY INSTRUCTIONS
INSTALLATION Tools required (not provided): • • • • • Pencil Hammer Level Screw Driver Power Drill and drill bits A wall/ceiling mounting bracket is provided with the heater which has been specifically designed to allow this product to be fitted to a wall or ceiling. Before drilling the holders, confirm that the wall is solid and that there are no hidden water pipes or electric wires. CAUTION! The appliance must be installed on a solid surface.
1. This heater should only be installed by a competent person. It is advised to use a qualified electrician. 2. Always disconnect the heater from the electricity supply and allow it to cool before handling or installing. Do not install the heater on a flammable surface. 3. For ceiling mounting, the lowest part of the heater must be located at or above a minimum height of 8 ft. from ground level, so that the heater cannot be touched when in operation. 4.
Wall / Ceiling Mounting: To install the plastic anchors into the wall, use a drill to place a hole in the wall. Using the hammer, tap the plastic anchor into the wall until it is flush.
The heater must be installed at least 6 feet above the floor Cord Positioning: The cord side of the heater should face downward when installed vertically or on an incline.
Mounting Angle REMOTE CONTROL: 1. POWER BUTTON: Turn the heater on/off. 2. LEVEL BUTTON 1: Press the level button to adjust the heat level to level 1 (750W). 3. LEVEL BUTTON 2: Press the level button to adjust the heat level to level 2 (1500W). To replace the battery, press the battery compartment release button and then slide out the battery tray.
TROUBLESHOOTING: The heater contains no user-serviceable parts. Troubleshooting is limited to checking the power source: 1. Check if the unit is turned on. 2. Check if the power cord is plugged into a properly-grounded electrical outlet. 3. Check if the electrical outlet’s circuit breaker/fuse is on and working MAINTENANCE: Periodic inspection and removal of dirt and contaminants will ensure that the heater can be operated safely.
5. The heater contains no user-serviceable parts. If the product is damaged or otherwise malfunctioning, it must be returned to the manufacturer or its service agent or it must be properly disposed of. Do not attempt to repair or adjust any electrical or mechanical functions on this heater. 6. Damaged supply cords must be replaced by a service agent or similarly qualified person in order to avoid hazard.
