Instructions / Assembly
Wall / Ceiling Mounting:
To install the plastic anchors into the wall, use a drill to place a hole in the wall. Using the hammer,
tap the plastic anchor into the wall until it is flush.
Cord Positioning:
The cord side of the heater should face downward when installed vertically or on an incline.
Correct Installation Incorrect Installation
Installation with stand:
Remote Control Instructions:
1. POWER BUTTON: Turns the heater off.
2. UP BUTTON: Increase temperature, timer and level.
3. DOWN BUTTON: Decrease temperature, timer and level.
4. LEVEL BUTTON: Press the level button to adjust the 2 heat levels (L1, L2) by pressing up and
down buttons to increase or decrease the heating level.