Instructions / Assembly
9
ASSEMBLY INSTRUCTIONS
8. Slide reflector plate onto reflector panels.
Insert one
screw M6 X 10 (II). Slide one washer Φ 6
over threaded end of
screw M6 X 10 (II) and screw on
cap nut (JJ) loosely. Repeat procedure to complete
the assembly of all four sections. Fully tighten all of
the
screws in the rolled edge.
JJ
HH
II
TT
8
Hardware Used
GG
KK
9
9. Support heater. Slide three washers washer Φ8 (GG)
over threaded end of spacer. Locate reflector assembly
on 3 spacers. Install three washers Φ8 on spacers and
securely tighten wing nuts (KK) but do not overtighten.
x 6
Washer Φ8
x 3
Wing nut
KK
GG
FF
GG