Installation Guide

Page 6 of 6
Figure 1
Figure 3
Step 2. Assemble the table legs (B) to the table top (A) with bolts (D&E) and washer (F) as shown in figure 1.
Figure 2
A
E
D
B
F
F
G
G
E
C
F
G
Step 4. Check the alignment and adjust if necessary. Once the alignment is correct, tighten all bolts with
open wrench ( ) . Cover all bolts with bolt caps(G).
Step 5. Verify all bolts are securely tightened before use and turn your table right side up. Your table is
now ready to use. (Figure 3).
H
Assembly Steps:
Note: Do not fully tighten bolts until assembly is completed and alignment is correct.
Step 1. Carefully place the table top (A) upside down on a non-abrasive surface.
Step 3. Loosely attach the support bar (C) to the table leg (B) and table top (A) with bolts (E) and washer (F)
as shown in figure 2.