User Manual

1 CLK / MEM Button 11 ALARM2 RADIO Indicator
2
/HR Button
12 ALARM1 BUZZER Indicator
3
/MIN Button
13 ALARM1 RADIO Indicator
4 DIMMER Button 14 BATTERY Compartment
5
ALM2/VOL− Button
15 AC Power Cord
6
ALM1/VOL+ Button
16 FM Wire Antenna
7 ALARM OFF/SOURCE/ Button 17 AUX-IN Jack
8 SNOOZE/SLEEP Button 18 PM Indicator
9 LED Display 19 SPEAKER
10 ALARM2 BUZZER Indicator
- 4 -
CONNECTING THE UNIT TO POWER
Plug AC power cord to the AC wall outlet. Before switching on the unit, make sure that the voltage
of your electricity supply is the same as that indicated on the rating plate.
BATTERY BACKUP
Insert two pieces UM-4 batteries into the battery compartment. Be sure to observe the proper
polarity (the "+" and "-" signs) as indicated inside the battery compartment.
In case of power failure or interrupted AC power, the current time and alarm time settings, the
stored radio stations are preserved in the memory of the unit by means of battery back-up function.
SETTING THE CLOCK
1. With the unit in CLOCK mode (RADIO is off), press and hold the CLK/MEM button for about 1
second, the time will begin to flash on the LED display.
2. Press the
/HR button to adjust the hour.
3. Press the
/MIN button to adjust the minute.
4. When the correct time is selected, press the CLK/MEM button again to confirm.
SETTING THE ALARMS
1. With the unit in CLOCK mode (RADIO is off), press the ALM1/VOL+ or ALM2/VOL− button.
The ALARM time will begin to flash on the LED display.
2. Press the
/HR button to adjust the alarm hour.
3. Press the
/MIN button to adjust the alarm minute.
4. When the correct time is selected, press the ALM1/VOL+ or ALM2/VOL− button to confirm.
5. Press the ALM1/VOL+ or ALM2/VOL− button to select the ALARM sound mode - buzzer or
currently set radio station. The alarm buzzer or radio indicator will light up.
SNOOZE FUNCTION
1. Whenever the alarm (radio or buzzer) activates, it can be temporarily suspended for a short
period of 9 minutes by pressing the SNOOZE/SLEEP button once.
2. The buzzer or radio will then automatically activate again after the 9 minutes SNOOZE period
has ended.
3. This procedure can be repeated for up to approximately one hour.
TURN OFF THE ALARM
When the Alarm activate, press the ALM OFF/SOURCE/ button to turn off the Alarm.
DISPLAY BRIGHTNESS
Press the DIMMER button to change the display brightness.
- 5 -