User Guide

ANALOG OUTPUT

All models pH 500XY1 and mV 600XY1 are provided with the

analog output feature.

The output is isolated and can be a voltage or a current.

With the recorder, simply connect the

common port to the ground output

and the second port to the current

output or voltage output (depending

on which parameter is being used)

as depicted aside.

The type (voltage or current) and the range of the output

analog signal is selectable through the jumpers on the

power board.

Configurations of the switch are as follows:

Output Switch 1 Switch 2 Switch 3 Switch 4

0-5 VDC, 1-5 VDC OFF ON – – – –

0-10 VDC ON OFF – – – –

0-20 mA, 4-20 mA – – – – ON – –

0-1 mA – – – – OFF – –

Choice between different ranges with the same configura-

tion (for example 0-20 mA and 4-20 mA) is achieved via

software by entering the setup mode and selecting code

40 (see Setup Mode section for exact procedure).

Factory default is switches 1 and 3 closed (ON) and switches

2 and 4 open (OFF), i.e. 0-20 mA, 4-20 mA, and 0-10

VDC.

In any case, contact the nearest Hanna Customer Service

Center for changing of the default configuration.

By default the minimum and maximum values of analog

output correspond to the minimum and maximum of the

range of the meter. For example, for the pH 500 series

with a selected analog output of 4-20 mA, the default val-

ues are 0.00 and 14.00 pH corresponding to 4 and

20 mA, respectively.