User Guide

PROBE MAINTENANCEPROBE MAINTENANCE

PROBE MAINTENANCE

Rinse the probe with clean water after measurements. If a more

thorough cleaning is required, remove the probe sleeve and clean the

probe with a cloth or a nonabrasive detergent. Make sure to reinsert

the sleeve onto the probe properly and in the right direction. After

cleaning the probe, recalibrate the instrument.

The platinum rings support is made of glass. Take great care while

handling the probe.

Connect the meter

to a PC through the RS232 output (#11 on page

4). Use HI 920010 (9 to 9-pin) connection cable.

The meter must be in measurement mode to communicate.

The meter RS232 port is optoisolated and transmits data with a Baud

rate of 2400 bps.

Retrieve the GLP data and request the meter parameters and the

current reading (of the current range only) from the PC directly. It is

also possible to send a command from the PC to set the meter in a

different range.

To communicate with the PC use the HI 92000 communication soft-

ware. The software is provided with an exhaustive on-line guide of all

the commands available and allows data printing, plotting and ex-

porting.

DATA TRANSFER TO PCDATA TRANSFER TO PC

DATA TRANSFER TO PC