User Guide

Setup can be used to view data regarding instrument status (e.g.

battery charge) or GLP data (e.g. calibration date) or to view or print

the logged data. It also allows the user to change the meter param-

eters (e.g. time) and to gain access to stored data.

• To enter this mode ensure the meter is

not logging and then press the ALT and

FNC keys.

• The scrolling message "Insert the function code or press "ALT" -

"FNC" to escape" in the upper LCD and the indication "F 00" with

the first digit blinking in the lower LCD will be displayed.

• Enter the first digit of the code of the parameter you want to set

using the  or  key and pass to the next digit with . The

second digit will start blinking.

• Enter the second digit using the  or

 key.

• Press ALT and CFM to confirm the code.

• If the entered code doesn't exist the "Err"

message will be displayed for a few sec-

onds and then the message "Insert the

function code or press ALT - FNC to es-

cape" will recommence scrolling in the

upper LCD.

SETUP MODE