User Guide

TO STOP PRINTING

In order to stop the recording mode, press

ALT and LOG keys (press ON/OFF first, if

meter is in sleep mode).

A last printout reporting the number of printed

samples (e.g. S.00009) will be produced.

Notes:

• It is recommended to use the adapter during printing mode,

especially when many printouts are going to be taken.

• Before proceeding with printing, make sure there is enough paper

for your measurements. When the paper is finished the meter will

not advise the operator and the printouts could be lost.

• It is possible to insert a new paper roll during printing session.

• Once in the timed printing mode, the interval cannot be changed.

Exit the timed printing mode first (pressing the ALT and LOG keys)

to set a new interval.

• If the LOG key is pressed while in timed printing mode, a printout

is produced without affecting the running sample number.

LOW BATTERY CONDITION

Printing is automatically interrupted when

battery charge weakens. The last message

"Stop log" will be printed and the LOBAT

symbol will blink on LCD.

Note: When an external adapter or new batteries are connected, a

new printing session must be manually restarted.

LOG ON DEMAND

In measuring or timed printing mode, press LOG to

print the current readings. The printout provides the

following information:

a - Date

b - Sample number

c - Time

d - Readings ("----" means out of

range or probe not connected)

Note: If the user attempts to print while in low battery condition the

message "bAtt" will appear for a few seconds on the LCD.

Note: It is possible to reset the sample number of the print on

demand to 001 (see "TO RESET PRINTING SAMPLE NUMBER"

in "SETUP MODE" paragraph).