User Guide

ManualsBrandsHanna Instruments ManualsMeasuring instrumentsHI 98106

1

Visit our Internet Home Page:

http://www.hannainst.com

SPECIFICATIONS:SPECIFICATIONS:

SPECIFICATIONS:SPECIFICATIONS:

SPECIFICATIONS:

RANGERANGE

RANGERANGE

RANGE 0.0 to 14.0 pH

RESOLUTIONRESOLUTION

RESOLUTIONRESOLUTION

RESOLUTION 0.1 pH

ACCURACY ACCURACY

ACCURACY ACCURACY

ACCURACY

(@20C/68F)(@20C/68F)

(@20C/68F)(@20C/68F)

(@20C/68F)

±0.2 pH

TYPICAL EMC DEVIATIONTYPICAL EMC DEVIATION

TYPICAL EMC DEVIATIONTYPICAL EMC DEVIATION

TYPICAL EMC DEVIATION ±0.1 pH

CALIBRATIONCALIBRATION

CALIBRATIONCALIBRATION

CALIBRATION Manual, at 1 point through trimmer

ENVIRONMENTENVIRONMENT

ENVIRONMENTENVIRONMENT

ENVIRONMENT 0 to 50C

(32 to 122F); 95% RH

BATTERY TYPEBATTERY TYPE

BATTERY TYPEBATTERY TYPE

BATTERY TYPE 4 x 1.5V alkaline (included)

BATTERY LIFEBATTERY LIFE

BATTERY LIFEBATTERY LIFE

BATTERY LIFE approx. 800 hours

of continuous use

DIMENSIONSDIMENSIONS

DIMENSIONSDIMENSIONS

DIMENSIONS 175 x 41 x 23 mm

(7.9 x 1.8 x 1")

WEIGHTWEIGHT

WEIGHTWEIGHT

WEIGHT 78 g (2.7 oz.)

ACCESSORIES:ACCESSORIES:

ACCESSORIES:ACCESSORIES:

ACCESSORIES:

HI 73106HI 73106

HI 73106HI 73106

HI 73106 Spare electrode

HI 77400PHI 77400P

HI 77400PHI 77400P

HI 77400P pH 4.01 & 7.01 calibration kit

(5 x 20 mL, each)

HI 77700PHI 77700P

HI 77700PHI 77700P

HI 77700P pH 7.01 calibration kit

(10 x 20 mL)

HI 770710PHI 770710P

HI 770710PHI 770710P

HI 770710P pH 7.01 & 10.01 calibration kit

(5 x 20 mL, each)

HI 7004MHI 7004M

HI 7004MHI 7004M

HI 7004M pH 4.01 buffer solution

(230 mL bottle)

HI 7007MHI 7007M

HI 7007MHI 7007M

HI 7007M pH 7.01 buffer solution

(230 mL bottle)

HI 7010MHI 7010M

HI 7010MHI 7010M

HI 7010M pH 10.01 buffer solution

(230 mL bottle)

HI 70300MHI 70300M

HI 70300MHI 70300M

HI 70300M Storage solution (230mL)

HI 7061MHI 7061M

HI 7061MHI 7061M

HI 7061M Electrode cleaning solution

(230mL bottle)

HI 731326HI 731326

HI 731326HI 731326

HI 731326 Calibration screwdriver (20 pcs)

IS98106-R3 09/01

ELECTRODE REPLACEMENT:ELECTRODE REPLACEMENT:

ELECTRODE REPLACEMENT:ELECTRODE REPLACEMENT:

ELECTRODE REPLACEMENT:

The electrode can be easily replaced in the following

way:

• Slide off the battery cover.

• Remove the screw on the back of the

ChampChamp

ChampChamp

Champ

located below the battery compartment and slide

off the whole internal part of the tester.

• To remove the electrode proceed as follows:

Remove the fastening screw on the front (1) to

loose the electrode. The internal circuit is con-

nected to the electrode through two wires (one

for the glass sensor and one for the reference).

Remove the two small screws (2 & 3) which

fasten the two connecting wires to their sock-

ets.

• Remove the electrode and

replace it with a new

HI73106.

• Connect the new electrode

as follows:

first fasten the screw on the

front (1) to attach the elec-

trode to the circuit. Insert

the two small wires into

their sockets and fasten the

two screws (2 & 3).

• The new electrode is supplied with four new O-

rings (4). Make sure they are placed properly

(as shown on the above drawing) before

reinserting the circuit into the plastic casing.

• Reinsert the internal circuit with the new

electrode into the plastic casing.

Internal circuit and electrode:

• Fasten the screw on the back below the

battery compartment.

• Reinsert the battery compartment cover.

• Perform a new calibration before using the

ChampChamp

ChampChamp

Champ

again.

ChampChamp

ChampChamp

Champ

®®

®®

®

HI 98106

Pocket-sized pH Meter

HI73106

ONE YEAR WARRANTY & SERVICEABLE:ONE YEAR WARRANTY & SERVICEABLE:

ONE YEAR WARRANTY & SERVICEABLE:ONE YEAR WARRANTY & SERVICEABLE:

ONE YEAR WARRANTY & SERVICEABLE:

Covered by

one yearone year

one yearone year

one year warranty against defects in work-

manship and materials, this tester is now completely

serviceable. Contact your dealer for further information.

The

ChampChamp

ChampChamp

Champ is in compliance with the CE directives EN

50082-1, EN 50081-1 and EN 61010-1.

Champ

®

is a registered Trademark of "Hanna Instruments"