User Guide

27
27
LOG
The meter is now in the printing/logging mode
utilizing log number 1, page 16. "LOG" and P
15 shown in the secondary display indicate
that the meter has entered the log mode, and
has 15 pages of available memory remaining.
After the initial printout, the time and printing/
logging interval will reappear.
Press the LOG key to view the running log
and page numbers.
Press the LOG key again to view the running
sample number
Step Three - Stopping the printer during the
log mode:
After the third printout is complete, press the
ALT and PAPER keys. At this point the
meter will continue to log data every 2 min-
utes but will no longer print any information.
"LOG" will keep blinking on the secondary
display for the remainder of "L 01" (log num-
ber 1).
Note: If the display has shut off press TEMP
to reactivate it.
INTV
TIME
LOG
LOG
LOG
UP
PAPER
ALT
PRINT
LOG
Untitled-10
28
28
UP DOWN
TIME LOG
ALT
TEMP
LOG
DOWNALT
UP
DOWN
ALT
TEMP
Step Four - Leaving the log mode:
Once the number of samples stored in memory
has reached 10, press the ALT and LOG
keys. The meter will exit the log mode after
generating a log exit status printout.
Step Five - Reviewing the stored data in
sample number 1:
Press LOG key to enter the memory recall mode.
The next available log and page number will be
shown on the display.
Press the ALT and DOWN keys until the
number 10 and "L1" appear, indicating that a
total of 10 samples were recorded in log
number 1.
To view the data stored in sample number 1 first
use the UP and DOWN keys to scroll through the
sample numbers.
Once the number is displayed, press the ALT
and TEMP keys. The date during which that
sample was taken will appear first.
10-01-96
==01== 0002M
0010 *00.18
DATE