User Guide

23
23
UP
ALT
TEMP
TO SCAN STORED DATA ON DISPLAY
Press the LOG key. The display will show
the log number and the page number of the
next logging.
While pressing the ALT key, press DOWN
until the log number to scan appears on the
secondary display. The primary display will
show the number of samples of that particu-
lar log.
Press ALT and TEMP simultaneously. This
now shows the date on which the log started.
Press UP and the time will be displayed.
LOG
DOWNALT
TIME
DATE
Untitled-10
24
24
Press UP and the temperature will be dis-
played.
Continue pressing UP to display all the memo-
rized data of the same log one by one in the
above sequence i.e. time, temperature value/
s.
Press the DOWN key to revert back to sam-
pling time and move back through samples.
To exit from the recall mode
press LOG.
Note: this mode will not alter data into
memory
CH
°C
LOG
TO PRINT STORED DATA
Once a log number is se-
lected by using the ALT and
DOWN, as detailed in the
chapter "TO SCAN STORED
DATA ON DISPLAY" you can
print all or part of that log
section by using the ALT and
PRINT keys. The printer will
start to print the logged sec-
tion beginning with the se-
lected sample number with-
out altering the content of the
memory.
Note: It is always possible to
print only the sample
shown on the display
by pressing PRINT.
DOWNALT
PRINT
PRINT
ALT