User Guide

21
21
If no key is pressed, the display goes blank
after about 5 minutes. During printing, the
display shows the time, interval and the “LOG”
symbol.
To reactivate the display
press the TEMP key.
The printout provides the following informa-
tion:
a - Date (DD-MM-YY)
b - A running log number
c - A running sample number (in that particu-
lar log)
d - Printing interval indicator in minutes
e - Time (HH-MM)
f - Temperature value/s
g - Channel # (HI955302 only)
It is always possible to switch from the log-
ging with printing function to the logging only
function. Press the ALT and the PAPER keys
at the same time and the "LOG" symbol will
start to blink to indicate that the data are now
stored only into memory.
Notes:
• It is recommended to use the adapter
during logging with printing mode, espe-
cially when many printouts are going to
be taken.
TEMP
LOG INTV
TIME
10-01-96
==07== 0005M
0014 *14.25
#1 25.0 °C
#2 27.3 °C
.
.
b
c
d
a
e
f
CH
°C
LOG
UP
PAPER
ALT
PRINT
Untitled-10
22
22
• Before proceeding with logging and print-
ing, make sure there is enough paper for
your measurements. When the paper is
finished the meter will not advise the op-
erator and the printouts could be lost. If
this happens, data will continue to be
stored into memory, and it is always pos-
sible to print them at different time (see
above).
• It is possible to insert a new paper roll
during logging session (see page 31)
• Once in the logging mode,
the interval cannot be
changed. Exit the logging
mode first (pressing the
ALT and the LOG keys)
before setting the new in-
terval.
• If the PRINT key is
pressed while in logging
mode, a printout is pro-
duced without affecting the
running sample number.
TO STOP LOGGING
Press ALT and LOG keys si-
multaneously, this will gener-
ate a log exit status printout.
UP DOWN
TIME LOG
ALT
TEMP
PRINT
UP DOWN
TIME LOG
ALT
TEMP
10-01-96
==07== 0005M
0016 *16.25
Log number
Total sample number
LOG EXIT
Date/Time