User Guide

19
19
UP DOWN
TIME LOG
ALT
TEMP
LOG
Log number
Page number
The printer will print a complete set of data
and the "LOG" symbol will appear on the
bottom left corner of the LCD.
To continue logging without printing, press
now the ALT and the PAPER keys at the
same time and the "LOG" symbol on display
will start to blink.
After approximately 5 minutes the display will
switch off but the logging function remains
active.
To reactivate the display
press the TEMP key.
If you wish to restart printing press the ALT
and PAPER keys simultaneously again.
The printout provides the following informa-
tion:
a - Date (DD-MM-YY)
b - A running log number
c - Running sample number (in that particular
lot)
d - Printing interval indicator in minutes
e - Time (HH-MM)
f - Temperature value/s
CH
°C
LOG
==07== 0005M
0001 *14.25
#1 25.0 °C
#2 27.3 °C
.
.
CH
°C
LOG
UP
PAPER
ALT
PRINT
TEMP
10-01-96
==07== 0005M
0014 *14.25
#1 25.0 °C
#2 27.3 °C
.
.
b
c
d
a
e
f
Untitled-10
20
20
Notes:
• Once in the logging mode,
the interval cannot be
changed. Exit the logging
mode first (pressing the
ALT and the LOG keys)
before setting the new in-
terval.
• If the PRINT key is pressed
while in logging mode, a
printout is produced with-
out affecting the running
sample number.
SAMPLE NUMBER
During logging it is possible
to know the running sample
number. Press the LOG key
twice and the display will
show the number of values
that have been taken in the
current log.
LOGGING MODE WITH PRINTING
This function is suggested when an immedi-
ate report of the measurement is required in
addition to the recording of the data into
memory.
Press the ALT and LOG keys
simultaneously to enter the
logging mode. The log num-
ber and page number will ap-
pear for a few seconds on the
display to indicate the correct
operational mode. The printer
will print a complete set of
data and the "LOG" symbol
will appear on the bottom left
corner of the display.
UP DOWN
TIME LOG
ALT
TEMP
LOG
LOG
UP DOWN
TIME LOG
ALT
TEMP
LOG
PRINT