User Guide

If the batteries become weak the meter will

display "LOW BAT".

The warning message is to alert the user that

the display will be shut-off after about 5 hours of use. After that, the

meter shuts down the display, preventing the taking of erroneous

measurements due to low voltage.

Battery replacement must only take place in a

non hazardous area using the battery types

specified in this instruction manual. To re-

place rundown batteries, remove the two screws

on the rear cover of the instrument and re-

place all four 1.5V AA batteries with new

ones, while paying attention to the correct

polarity. Replace the cover and tighten the

two screws. The meter is reset any time the

batteries are removed. In case of any func-

tional problems, reset the meter by removing

and reinstalling the batteries.

AUTO-OFF CAPABILITY

The battery compartment has an auto-off switch. To disconnect this

function, turn the switch to the "ALWAYS ON" position. If the switch is

in the "AUTO OFF" position, the meter will shut itself off automatically

after 10 minutes of non-use.

1.5V

LOW BAT

BATTERY REPLACEMENT & AUTO-OFFBATTERY REPLACEMENT & AUTO-OFF

BATTERY REPLACEMENT & AUTO-OFF