User Guide
2524
To exit from the recall mode press the LOG key.
Note: this mode will not alter data already present in the memory.
LOG
TO PRINT STORED DATA
Once a log number is selected (see "TO SCAN
STORED DATA ON DISPLAY" on page 23) you
can print all or part of that logged section by
pressing the ALT and PRINT keys. The printer
will print all the logged samples in that section
beginning with the selected sample number
without altering the content of the memory.
Note: It is always possible to print only the
sample shown on the display by pressing
the PRINT key.
For example if 10 samples are stored in the
logging section, use the DOWN key to display
sample No. 5.
Sample # 5 can be printed on its own using
the PRINT key.
Sample # 5, 6, 7, 8, 9 and 10 are printed
when ALT and PRINT are pressed simulta-
neously.
If you wish to stop the printer press ALT and
PAPER together.
Note: Before proceeding with printing, make
sure there is enough paper for the data
to be printed. If the paper runs out, the
meter will not advise the operator and
the printouts could be lost. If this hap-
pens, stop the printer by pressing ALT
and PAPER key simultaneously. Data will be kept in memory.
Insert a new paper roll and repeat the instructions above
starting from the last printed sample number (see "PRINTER
MAINTENANCE" on page 31 for changing the paper roll).
DOWNALT
PRINT
ALT
PRINT
DOWN
PRINT
PRINT
ALT
UP
PAPER
ALT
PRINT
UP
PAPER
ALT
PRINT
While pressing the ALT key, press the DOWN key until the log number
to scan appears on the secondary display. The primary display will
show the number of samples in that particular log.
Press the ALT and the RANGE keys simultaneously. This now shows the
date when logging started.
Press UP and the time of the most recent sample will be displayed.
Press UP and the temperature will be displayed on the primary LCD.
Press UP and the RH% value will be displayed on the primary LCD.
Continue pressing UP to display one by one all
the memorized data of the same log in the above
sequence i.e. time, temperature, RH% value.
Press the DOWN key to revert back to sampling
time and scan the samples.
DOWNALT
ALT
RANGE
DATE
TIME
UP
°C
UP
UP
DOWN
UP