User Guide

15
14
TEMPERATURE PROBES & ACCESSORIES
Hanna Instruments offers a wide range of
probes to meet all your requirements from
liquids to air and penetration to surface.
These probes use highly sensitive thermistor
sensors which provide greater accuracy,
faster response and a temperature range
that is superior to conventional thermistor
probes.
All Hanna temperature probes are supplied
pre-calibrated from the factory and are ready
to be used with your meter.
The probes are easily connected to your
meter with a standard RCA jack.
Completely interchangeable, these probes
make it possible to switch from one to an-
other without wasting time and money going
through tedious calibration procedures.
They are available in different colors to avoid
cross contamination during testing:
For HI 9060 and HI 9061:
HI765A Air probe, with 1 m (3.3') cable and
white handle
HI765A/10 Air probe, with 10 m (33') cable
and white handle
HI765BL General purpose liquid probe, with
1 m (3.3') cable and black handle
HI765BL/10 General purpose liquid probe, with
10 m (33') cable and black handle
HI765L General purpose liquid probe, with
1 m (3.3') cable and white handle
HI765L/10 General purpose liquid probe, with
10 m (33') cable and white handle
HI765PBL Penetration probe with 1 m (3.3')
cable and blue handle
HI765PBL/10 Penetration probe with 10 m (33')
cable and blue handle
HI765PG Penetration probe with 1 m (3.3')
BATTERY REPLACEMENT
When the batteries be-
come weak, the meter
displays "Eb" (for
HI9060 and HI9061) or
"BAT" (for HI91541) to
warn the user.
Battery replacement must only take place in
a non hazardous area using the battery types
specified in this instruction manual (see
page 17).
In order to replace rundown
batteries, simply remove
the two screws on the rear
cover of the instrument and
replace the four batteries
with new ones paying at-
tention to the correct po-
larity.
Replace the cover and
tighten the two screws.
BAT