User Guide

ManualsBrandsHanna Instruments ManualsOtherHI 9032

1

2

3

4

5

6

7

8

9

76

• ON key, to switch the instrument on

• OFF key, to switch the instrument off

• CAL key, to enter or exit the calibra-

tion mode

• CON key, to confirm calibration data

• ENTER Key, to confirm/enter the nu-

meric data entry

• 0 to 9 keys, numeric and decimal keys

for numeric data input

• Clear Key, to clear the numeric data

entry

If the temperature

probe is discon-

nected during operation, the decimal point

will start blinking.

It will blink also if

the temperature

range is exceeded.

This LCD also displays the program # during

programming.

3. Calibration Procedure

Briefly describes calibration

procedure

4. Keyboard

• Cond key, to select conductivity mea-

surement mode

• Fert. key, to select fertilizer measure-

ment mode and to select Fertilizer #1

or #2 ("F1" or "F2")

• NaCl key, to select NaCl measure-

ment mode

• T.D.S. key, to select total dissolved

solids measurement mode

• FTR key, to select the TDS factor for

TDS measurements (see page 45)

•°C key, to display temperature in the

Celsius scale

•°F key, to display temperature in the

Fahrenheit scale

• ATM/MTC key, to select automatic or

manual temperature compensation

• %T.C. key, to select the temperature

coefficient for conductivity measurements

or to select a different conductivity buffer

during calibration (see page 21)

• PGM key, used in programming

Secondary Display

Primary Display

°C

F1

F2

LO BAT

SAMPLE

HOLD

CONDUCTIVITY

TDS

FERTILIZER NaCl

CON

CAL

BUF

%TC

S

m

µ

ppm

%

gm

HI

LO

Large display for Conductivity, Fertilizer, NaCl

and TDS

TEMP. display for temperature in °C or °F

and program #

LIQUID CRYSTAL DISPLAYS