User Guide

6362
CE DECLARATION OF CONFORMITY
Recommendations for Users
Before using this product, make sure that it is entirely suitable for the environment
in which it is used.
Operation of this instrument in residential area could cause unacceptable interfer-
ences to radio and TV equipments, requiring the operator to take all necessary steps
to correct interferences.
The metal band at the end of the probe is sensitive to electrostatic discharges. Avoid
touching this metal band at all times.
During operation, ESD wrist straps should be worn to avoid possible damage to the
electrode by electrostatic discharges.
Any variation introduced by the user to the supplied equipment may degrade the
instrument's EMC performance.
To avoid electrical shock, do not use this instrument when voltages at the measure-
ment surface exceed 24VAC or 60VDC.
To avoid damages or burns, do not perform any measurement in microwave ovens.
DECLARATION OF CONFORMITY
We
Hanna Instruments Srl
V.le delle industrie 12
35010 Ronchi di Villafranca (PD)
ITALY
herewith certify that the bench conductivity meter
has been tested and found to be in compliance with the following regulations:
IEC 801-2 Electrostatic Discharge
IEC 801-3 RF Radiated
IEC 801-4 Fast Transient
EN 55022 Radiated, Class B
Date of Issue: 04-01-1996
D.Volpato - Engineering Manager
On behalf of
Hanna Instruments S.r.l.
HI 9032
WARRANTY
All Hanna Instruments meters are warranted
for two years against defects in workman-
ship and materials when used for their in-
tended purpose and maintained according to
the instructions.
The probes are warranted for a period of
six months.
Damages due to accidents, misuse, tamper-
ing or lack of prescribed maintenance are
not covered. This warranty is limited to repair
or replacement free of charge.
If service is required, contact the dealer from
whom you purchased the instrument. If un-
der warranty, report the model number, date
of purchase, serial number and the nature of
the failure. If the repair is not covered by the
warranty, you will be notified of the charge
for repair or replacement. If the instrument is
to be returned to Hanna Instruments, obtain
a Return Goods Authorization from the Cus-
tomer Service Department first and then send
it with shipment costs prepaid. When ship-
ping any instrument, make sure it is properly
packaged for complete protection.
To validate your warranty, fill out and return
the enclosed warranty card within 14 days
from the date of purchase.
All rights are reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.
Hanna Instruments reserves the right to
modify the design, construction and ap-
pearance of its products without advance
notice.