User Manual

ManualsBrandsHanna Instruments ManualsSensorsHI 8050

MANUAL STOP – S48

Active program: 03

Stop program: -- ?

PROG MAN STOP S48

Each program can be manually stopped using this panel. This panel displays

and allows the setting of the following parameters:

−

Active program - Active program -

Active program - The currently active program.

−

Stop programStop program

Stop program - The program selected for deactivation. User selectable.

CONTROLLER STATE – S49

STOP - WORK

WORK -

INIT -

CONTROLLER STATE S49

This panel allows manual manipulation of the controller state. Once entering

the set mode, one of the 3 conditions can be selected using the arrow keys. Y

(yes) can be entered next to the selected condition to change the controller

state. Only the Y (yes) key will have effect in activating the appropriate state.

This panel displays and allows the setting of the following parameters:

−

Current controller statusCurrent controller status

Current controller status – see top right corner

−

STST

OPOP

OP - Enter Y (yes) then

ENTERENTER

ENTER to place controller in stop state.

−

WORKWORK

WORK - Enter Y (yes) then

ENTERENTER

ENTER to place controller in work state. If

certain alarm conditions exist it is not possible to enter WORK state.

−

INITINIT

INIT - Enter Y (yes) then

ENTERENTER

ENTER to place controller in initialization state

(reset the controller).

OUTLET MAN CTRL – S50

Number: 27

Opened: Y

Value: -

OUTLET MAN CTRL S50

In this panel the outlet number is used as the index. See in Appendixes the

outlet assignment. This panel displays and allows the setting of the following

parameters:

−

Number - Number -

Number - Panel index. Outlet number.

−

OpenedOpened

Opened -The status of the indexed outlet.

−

aluealue

alue -Enter Y (yes) or N (no) to open or close the indexed outlet.