User Guide

32
Command Parameter Description
CAR null Request calibration data
GET N N Request setup item NN
K01 null Same as CFM++CAL keys
K02 null Same as LCD+CAL+SETUP keys
KCD null Same as CAL DATA key
KCF null Same as CFM key
KCL null Same as CAL key
KDS null Same as LCD key
KDW null Same as  key
KRG null Same as  key
KST null Same as SETUP key
KUP null Same as  key
MDR null Request firmware code
EC R null Request EC reading
(in control or idle modeonly)
TDR null Request TDS reading
(HI 710 models only, available in
control or idle mode only)
R NG null Request measure Range
(in control or idle mode only)
TMR null Request temperature reading
PWD NNNN Send the 4-digit password
SET NNPC
1
C
2
C
3
C
4
C
5
Set setup item NN to the
PC
1
C
2
C
3
C
4
C
5
value
P=+ if value is greater than 0
P=
- if value is less than 0
C
1
can be 0 or 1 only
C
2
C
3
C
4
C
5
can be 0÷9 or blank
(the command is not available if
the controller is in setup mode)