User Guide

If M1= 3 then S1+D1THA;

If M1= 4 then S1-D1ULA;

If M2= 1 then S2-H2ULA;

If M2= 2 then S2+H2THA;

If M2= 3 then S2+D2THA;

If M2= 4 then S2-D2ULA;

If M1= 1 and M2 = 2

then S1-H1US2+H2, S2ULA, HAUS1;

If M1 = 2 and M2 = 1

then S2-H2US1+H1, S1ULA, HAUS2;

If M1 = 3 and M2 = 2

then S1US2+H2, S2ULA, HAUS1+D1;

If M1 = 2 and M2 = 3

then S1+H1TS2, S1ULA, HAUS2+D2;

If M1 = 4 and M2 = 1

then S1TS2–H2, S1–D1ULA, HAUS2;

If M1 = 1 and M2 = 4

then S1–H1US2, S2–D2ULA, HAUS1;

If M1 = 3 and M2 = 4

then S1US2, S2–D2ULA, HAUS1+D1;

If M1 = 4 and M2 = 3

then S2US1, S1–D1ULA, HAUS2+D2;

where the minimum deviation (D1 or D2) is 0.5% of the maxi-

mum range value.

Note When a wrong setup value is confirmed,

the controller does not skip to the next setup

item but remains in the current item dis-

playing a flashing “ERROR” indicator un-

til the parameter value is changed by the

user (the same is also true for the setup code selection).

Note In some circumstances, the user cannot succeed in setting a

parameter to a desired value if the related parameters are not

changed beforehand; e.g. to set a EC high setpoint to 10.0

mS the high alarm must be set to a value greater than 10.0

mS first.