User Guide

Setup can be used to view data regarding instrument status (e.g.

battery charge) or to change the meter parameters (e.g. time).

• To enter this mode press (ALT+) SETUP

while the meter is in measurement mode.

• The setup code "00" will blink on the

secondary LCD and "SEt" will be dis-

played on the primary one.

• Select the code of the desired

parameter using the  or 

key.

• Press CFM to confirm the code.

Note: If (ALT+) SETUP are pressed before code confirmation, the

meter returns to measurement mode.

• If the selected parameter is password protected, the lower LCD will

display "PAS" and the password must be entered to proceed.

Otherwise, the current parameter value will be displayed.

PASSWORD PROTECTION

Setting of time, date and calibration alarm time-out are password

protected and the user will be asked to enter the password to change

these parameters. After code confirmation the upper LCD will display

"0000".

• If password is set to 0000 (factory setting), just press CFM to

confirm.

• If password is set to a value different from 0000, enter the

password with the up and down arrow keys and then press CFM

to confirm.

• If the password is not correct, the meter displays the "WRONG"

indication and asks for the password again.

• If the password is correct, the meter provides access to the

parameter.

SETUP MODE