User Guide

Otherwise, if a numeric value has to be entered for the

item, use the  or  key to change the value of the blink-

ing digit and the  key to cycle through the number’s

digits.

• Once a value is set, press the CFM key to confirm. The

instrument will turn to the next item and the new item’s

value will be displayed on the primary LCD.

• If a wrong value is confirmed, the

WRONG indicator starts blinking,

the new value is not accepted and

the instrument will not switch to the

next item until a correct value will

be confirmed.

• Instead of selecting the item manually, it is possible to cycle

through all the items of a selected group by pressing re-

peatedly CFM key. The procedure to modify the item’s value

is the same described above.

If the last item of the group is reached, by pressing the

CFM key again the primary display will show the group

name and it will be possible to change the group by press-

ing the  or  key.

Note At any time for exiting the setup mode press the SETUP key. If

no modification has been confirmed, no setup item is

changed.