Instruction Manual

50
Relative mVRelative mV
Relative mVRelative mV
Relative mV
MEASUREMENTS MEASUREMENTS
MEASUREMENTS MEASUREMENTS
MEASUREMENTS
To measure the Relative mV of a sample:
• Press
and then to enter Relative mV
Measure
mode.
• The instrument will display the measured Relative mV value
on the LCD, together with a short GLP information about the
last calibration or “Not Calibrated” message if no Rel mV
calibration was performed (no Rel mV offset set).
Notes: • If the measured mV potential is out of range, “-----”
will be displayed on the LCD.
• If pressing while in Relative mV Measure
mode, the Relative mV offset screen will be displayed
on the LCD. Press to clear the existing
Relative mV or use or to adjust
the Relative mV value and then press to save
the current Relative mV. Press at any time
to return to Relative mV Measure mode.
• Before performing a Rel mV calibration, make sure
that the electrode is immersed into the sample to be
measured.
67
Temperature
From the Temperature menu the user can choose the temperature
source and units, as well as the temperature compensation mode,
reference temperature and compensation coefficient.
To access a Temperature option:
• Use or to highlight the Temperature op-
tion from the Conductivity Setup menu.
• Press to access the Temperature option.
Temperature Source
To set the temperature source:
• Use or to highlight the Temperature Source
option.
• Press and then use or to select
Automatic or Manual temperature source.
• Press to confirm your selection or press to
cancel operation.